DUMP TRAILERS
Ravens® Double Wall (“DW”)
DOUBLE WALL
ALUMINUM DUMP TRAILER
Constructed from high strength aluminum alloys, Ravens ‘DW’ by Kruz is built without the bulk, improving your payload capacity.
Ravens ‘DW’ by Kruz double wall dump trailers — with their distinctive swirl finish — are available at dealers from coast to coast.
High Strength, Heavy-Duty, Aluminum Performance
OPTIONAL COAL DOOR LIGHT CONFIGURATION
OPTIONAL GROUND CONTROL
OPTIONAL TWO WAY TAILGATE
H.D. TOP AND BOTTOM RAIL PROFILE
| Body | |
| Rear Floor Sill | 8” wide x 4” deep extruded aluminum (6061-T6) |
| Floor | .230 aluminum plate (5454) |
| Sides | .150 extruded aluminum hollow panel (6061-T6) |
| Rear Post | Extruded aluminum (6061-T6), 8” wide x 4” deep with 1/2” lip to secure seal for gate |
| Top Rail | Extruded aluminum (6061-T6), 9″ x 6” |
| Front | .230 aluminum (5083), 3/8” x 4” aluminum band (6061-T6) around top. Bottom rail squared with mud flaps. |
| Holst Box | Tapered, fully enclosed, with inspection hole. |
| Tailgate | .150 extruded aluminum hollow panel (6061-T6). Heavy-duty steel bolt-on hardware. Overslung latches proved positive locking. Air operated controls are located roadside behind landing gear. Sealed tailgate around outside edge of gate. |
| Electrical | Sealed beam lights recessed in side panels. Mid turn signal center marker light. One light on rear post facing rear each side |
| Mud Flaps | Heavy-duty spray suppressant back rubber |
| Finish | Trademarked swirl. Steel parts painted black. Conspicuity tape. |
| Chassis | |
| Tires | 11R24.5 16ply |
| Wheels/Disec | Eight (8) 8.25 x 24.5″, 10-hole disk, hub piloted, unimount, plain aluminum wheels |
| Hubs | Four (4)10-stud Duralite, hub piloted. |
| Drums | Outboard mount light-weight hub piloted. |
| Brakes | 16-1/2″ x 7″ Q-plus, non-asbestos lining with quick-changes features, automatic slack adjustors, Meritor WABCO 4S/2M ABS system |
| Axles | Two tubular 5″ 25,000 lb capacity, 71-1/2″ track. |
| Suspension | Intraax 300 air ride, closed tandem, 49” axle spacing. |
| Bogle Frame | .312 Aluminum web, 5″ wide x 3/4″ thick bottom flange. |
| Frameless Draft Arms | Aluminum 3″ x 5.25″ tube with round tubular crossmember. Draft arms are hinged to upper coupler and outboard of body. |
| Landing Gear | Two-speed 50,000-Ib capacity with sand shoes, handle mounted roadside. |
| King Pin Plate | Frameless 5/16” and Frame type 3/8”, KP Setting18” from front |
| Holst Base | Frameless: Four 1/2” steel plate support tube for 2” hoist pin Frame Type: Heavy-duty, 8″ steel channels |
| Frame Type Rear Hinge | Rear Hinge Pin: 3″ O.D. steel tubing |
| Body Wear Pads | Fiber-reinforced rubber secured to top of frame, full length; protects body floor sills. |
| Hoist | Five stage, heavy duty |
| Electrical | DOT, sealed LED lights and harness |
| Finish | Swirl-finished aluminum suspension frame. All steel parts are painted black enamel. |
